Isostatic pressure test bench – Automatic control

1 Equipment Introduction

Isostatic hydraulic testing machine can carry out deep sea simulation experiment, its depth is up to 0-1000m (pressure range 0-10Mpa), widely used in underwater pipeline and underwater data protection vessel deformation and damage test under Marine high pressure, equipment adopts computer automatic control, computer control of the whole test process, can be arbitrarily set single or multi-section pressure holding test. The booster speed can be kept constant, the pressure can be automatically adjusted, the test data and curve parameters can be displayed in real time, the test results can be automatically saved, and the test report can be printed at will.

2 Application range

Used for deformation and failure test of underwater pipeline and underwater data protection vessel under high pressure of ocean. Submarine structural cabin, all kinds of submersibles, deep-water robots, deep-water equipment, deep-sea exploration instruments, sampling equipment, data acquisition equipment, etc., withstand pressure test under Marine high pressure.

Three-device composition

The test bed is composed of two parts: high pressure test chamber, console, computer control system, automatic acquisition system, electrical control system.

Four main technical parameters

Test pressure: 0-10MPa

Pressure test medium: clean water

Drive mode: compressed air

Driving pressure: 5-8bar

Pressure test pump configuration: high pressure liquid pump

Test station: 1 station

Pressure acquisition: pressure gauge, sensor

High pressure chamber size: φ200mm height 500mm

Control mode: Automatic

Device form: split type